ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARlNE CORPS TM 09244A/09245A-24/2
1. Dimensions shown are in inches.
2. Tolerances are 0.1 inch unless otherwise stated.
PROCEDURES:
1.
2.
3.
Cut foam to dimensions shown.
Drill holes as shown.
Coat this edge using sealant (Item 17, Appendix C).
FIGURE D-29. Insulation, Top Center (P/N: 88-22605)
D-29
