ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARlNE CORPS TM 09244A/09245A-24/2
APPENDIX D
FABRICATION/ASSEMBLY
D-1 INTRODUCTION.
OF PARTS
This appendix includes complete instructions for fabricating or assembling parts as required on this generator set.
NOTE
All dimensions are expressed in inches, refer to TABLE D–1 for inches to metric con-
versions.
D-2 ILLUSTRATIONS.
NOTES:
1. Dimensions shown are in inches.
2. Refer to TM 9-6115-645-24P for materials required and length (L) of each end of wire.
PROCEDURES:
1.
2.
3.
Cut wire (1) to length indicated.
Strip 0.75 inch of insulation from each end of wire (1).
Crimp terminal (2) on each end of wire (l).
FIGURE D-1. Cable Assembly, AC Power (P/Ns: 88-22128-1 through 88-22128-7)
D-1
