ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
CHAPTER 3
GENERAL MAINTENANCE INSTRUCTIONS
SECTION 1. REPAIR PARTS; TOOLS; TEST MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SPECIAL SUPPORT EQUIPMENT
3-1 MAINTENANCE REPAIRS PARTS.
Repair parts and equipment are listed and illustrated in the repair
9-6115-645-24P.
3-2
TOOLS AND EQUIPMENT.
There are no special tools or support equipment required to perform anv
parts and special tools list manual TM
level of maintenance on the generator set.
A list of recommended tools and support equipment required to maintain the generator set is contained in Appendix B,
SECTION Ill.
3-3 FABRICATION OF TOOLS AND EQUIPMENT.
No requirement exists for fabrication of tools and equipment for maintenance of the generator set.
SECTION Il. TROUBLESHOOTING
3-4
DIRECT SUPPORT TROUBLESHOOTING PROCEDURES
3-4.1
Purpose of Troubleshooting Table. This section contains troubleshooting information for locating and correcting
operating troubles which may develop in the generator set. Each malfunction for an individual component, unit, or system
is followed by a list of tests or inspections which will help you to determine probable causes and corrective actions to take.
You should perform the tests/inspections and corrective actions in the order listed.
This table cannot list all malfunctions that can occur, nor all test or inspections and corrective actions. If a malfunction is not
listed or cannot be corrected by listed corrective actions, notify your supervisor.
NOTE
Before you use this table, be sure you have performed your PMCS.
NOTE
Before you use this table, be sure lower level troubleshooting steps have been per-
formed.
NOTE
Refer to the Electrical Schematic FO-1 and Wiring Diagram FO-2 as troubleshooting
aids. Refer to diagnostic connector TABLE 2-9.
3-1
