ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
g.
h.
4.23.3
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
Feed main stator (30) and exciter stator (14) wires through generator housing (31) and up through end bell opening.
WARNING
Hot metal surfaces can cause burns to skin. Wear protective gloves and
eye protection when applying heat to generator housing. Failure to ob-
serve this warning could result in severe personal injury,
CAUTION
Ensure wires are not touching generator housing and are away from
open flame when heat is applied. Be sure to distribute heat evenly to
prevent damage to housing.
Apply heat evenly to ribs of generator housing (31) at the main stator (30) end using an acetylene torch with a rose
bud tip, refer to FIGURE 4-11 for rib locations. Heat ribs until main stator (30) drops down and liftoff housing (31).
Installation.
Stand generator housing (31, FIGURE 4-10) on end with end bell opening in a downward position.
Position main stator (30) in generator housing (31). Ensure stator wires are pointing downward and in alignment
with wiring port on side of generator housing (31).
W A R N I NG
Hot metal surfaces can cause burns to skin. Wear protective gloves and
eye protection when applying heat to generator housing. Failure to ob-
serve this warning could result in severe personal injury.
C A U T I ON
Ensure wires are not touching generator housing and are away from
open flame when heat is applied. Be sure to distribute heat evenly to
prevent damage to housing.
Apply heat evenly to ribs of generator housing (31) at main stator (30) end using an acetylene torch with a rose
bud tip, refer to FIGURE 4-11 for rib locations. Heat generator housing (31) ribs until main stator (30) drops into
position.
Install setscrews (29) in generator housing (31).
CAUTION
Special care must be taken when feeding wires to prevent damaging
or breaking off wires.
Feed main stator (30) and exciter stator (14) wires through wiring port on side of generator housing (31).
Retest main stator to ensure stator was not damaged during installation, paragraph 4.23.1.
Position exciter stator (14) and main stator (30) leads in lead clamp assembly (38).
Install lead clamp assembly (38) in brackets (37) with bolts (34), Iockwashers (33), and nuts (32).
Install rotor assembly, paragraph 4.22.3.
Install generator assembly, paragraph 4.16.2.
4-44
