ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
4.13.3
Repair.
WARNING
Wear protective mask and gloves when sanding CARC painted sur-
faces. CARC paint dust is a health hazard and could cause personal
injury if warning is not followed.
a. Repair all dents and cracks, and remove all loose paint.
b. Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
c. Replace damaged seals and grommets.
d. Repaint surfaces in accordance with TM 43-0139. (F) Refer to applicable directives.
4.13.4
Installation.
a. Install grommets (48, 49, and 50, FIGURE 4-3) in output box panels (3) and (51).
b. Install output box side panels (46) and (47) on output box bottom panel (51) with bolts (45) and nuts (44).
c. Install output box panels in generator set with bolts (7) and nuts (6).
d. Install cranking relay (43) with screws (42) and nuts (41).
e. Install AC circuit interrupter relay (40) with screws (39) and nuts (38).
f. Install current transformer, paragraph 4.10.3.
g. Install power potential transformer, paragraph 4.12.4.
h. Install droop current transformer, paragraph 4.11.3.
i.
Install voltage reconnection terminal board, paragraph 4.8.2.
j.
Install output box harness, paragraph 4.9.5.
k. Install air cleaner assembly, paragraph 2.72.4.
l. Install output box top panel (3) with bolts (2) and nuts(1).
m. If removed, install self- adhesive door seal (52) and EMI seal (53) with adhesive (Item 1, Appendix C) on output
box top panel (3).
n. Install output box access door, paragraph 2.14.4.
0. Install generator housing rear panel, paragraph 2.18.4.
p. Install control box assembly, paragraph 2.19.4.
q. Connect negative battery cable and close battery access door.
4-24
