ARMY TM 9-6115-643-10
AIR FORCE TO 35C2-3-445-21
screens covering ventilation areas, the external oil drain
2-23
USE
OF
THF.
CONVFNFIENCF
RFCFPTACI.E.
valve, and areas adjacent to the external fuel drain valve.
(6) Areas behind knobs and switches on the
control
panel,
externally
mounted
equipment
specification data plates, external receptacle covers,
access doors, access door locking mechanisms,
recessed wells for access door handles, fuel cap, load
terminal board, slave receptacles, and frequency
Power is available when the main
adjustment controls.
contactor is open.
Avoid accidental
contact.
Failure to observe this
Replacements of these items, if available, is the
warning can result in severe personal
preferred method of decontamination. Conventional
injury or death by electrocution.
methods of decontamination should be used on these
areas, while stressing the importance of thoroughness
and the probability of some degree of continuing contact
CAUTION
and vapor hazard.
The maximum power rating for the
f.
In an NBC contaminated environment, the
convenience receptacle is 10 Amps.
generator set should be operated with all access doors
Continuous operation above 10 Amps
closed to reduce the effects of contamination.
can result in damage to the generator
set.
g. The use of overhead shelters or chemical
protective covers is recommended as an additional
a. Start the generator set if it is not operating.
means of protection against contamination in
Refer to para. 2-10.
accordance with FM 35. However, if using covers, care
should be taken to provide adequate space for air flow
b. Ensure the load does not exceed the
and exhaust.
maximum rating.
h. For additional NBC information, refer to FM
c. Reset
the
Ground
Fault
Circuit
3-3 and FM 3-4.
Other services use applicable
Interrupter.
publications
for
NBC
d. Plug
appropriate
connector
into
convenience receptacle.
Change 3
2-41/(2-42 blank)
