ARMY TM 9-6115-842-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
Use care to avoid contact between frae/stator assembly (5) and rotor assembly
(18).
k. Attach lifting device to rotor assembly (18) and carefully lower rotor assembly (18) into frame/stator assembly
(5). Ensure bearing (19) enters bearing bore in end bell (31).
l.
Align mounting holes on fan (8) and drive plate (9), and wire together through two mounting holes.
m.
m. Install fan (8), drive plate (9), spacer (17), and retention disk (16) on rotor assembly (18) with lockwashers
(17) and bolts (14).Torque kits (14) 29 to 31 ft-lbs (39 to 42 Nm). -
a.
Install flywheel (10, FIGURE 4-25) to engine crankshaft with bolts (13). Torque bolts (13)48 to 53 ft-lbs (65
to 72 Nm).
Rated capacity of lifting device must be at least 1000 lbs (454 kg).
b.
c.
d.
e.
f.
g.
h.
Using overhead lifting device, carefully lift generator assembly and align with engine flywheel housing.
Install bolts (12) and tighten alternately to draw generator assembly and engine assembly smoothly and evenly
together. Torque bolts (12) 19 to 21 ft-lbs (26 to 28 Nm).
NOTE
The following step requires turning the generator by hand. Use engine fan to turn engine
and generator.
Align mounting holes and install bolts (6) and washers (7) securing fan (8) and drive plate (9) to flywheel (10).
Remove wires holding fan and drive plate together when installing bolts. Torque bolts (6) 29 to 31 ft-lbs (39 to
42 Nm).
Install screen (4) on generator frame/stator assembly (5) with lockwasher (3), washer (2), and bolt (1). Torque
bolt (1) 7 to 9 ft-lbs (9.5 to 12 Nm).
Remove wooden wedges from between engine and skid base.
Install generator mounting hardware, paragraph 3-6.2, step i.
Install rear housing section, paragraph 2-20.4.
4-30
I n s t a l l a t i o n .
4-12.6
