ARMY TM 9-6115-639-13
AIR FORCE TO 35C2-3-386-51
MARINE CORPS TM 10155A-13/1
5-7. ENGINE / ALTERNATOR ASSEMBLY MAINTENANCE - cont.
C. INSTALLATION.
WARNING
The engine / alternator assembly is heavy. Provide adequate lifting device to support the
weight. Do not lift object over personnel. Enlist the help of an aide to prevent damage to
equipment. Failure to observe this warning can result in personal injury.
1.
Install engine lifting cable (10, Figure 5-1) onto engine / alternator assembly (23) using screws (11).
2.
Attach lifting hoist to engine lifting cable (10, Figure 5-1). Raise hoist to remove slack.
3.
Carefully lift engine / alternator assembly (23) and mate to plate (18). Secure using four screws (19), eight
washers (20), and four nuts (21). Torque screws to 30 ft-lbs.
4.
Install three vibration isolators (14) to skid base (27) using screws (24), washers (25), and nuts (26).
5.
Lift engine / alternator assembly (23) and carefully lower into generator set enclosure. Mate mounting
holes on plate (18) with vibration isolators (14).
6.
Attach engine / alternator assembly (23) to vibration isolators (14) using screws (15), lockwashers (16),
and washers (17). Torque screws to 30 ft-lbs.
7.
Connect oil drain line (4) to drain valve (12) and secure by tightening clamp (13). If removed, secure drain
plug (6) to skid base (27) using screw (7), washers (8), and nut (9).
8.
Feed recoil winding mechanism starter rope through hole in skid base (27). Install tee handle and knot
rope to secure handle.
9.
Connect fuel line (3) to fuel filter / water separator outlet. Connect fuel line (2) from fuel tank to tee.
Connect fuel return line (1) to fuel injector.
10. Connect electrical wiring to engine components.
11. Attach support rods to main access cover (4-46).
12. Install muffler assembly (Para. 4-43).
5-8
