TM 55-6115-491-40
APPENDIX A
REFERENCES
The Army Maintenance Management System
APPENDIX B
REPAIR PARTS AND SPECIAL TOOLS LIST
(Current as of 1 Sept 70)
Section I. INTRODUCTION
(1) Source code. Indicates the selection
B-1.
SCOPE.
status and source for the listed item. Source codes are:
This appendix lists repair parts, special tools,
CODE
EXPLANATION
test and support equipment, and maintenance supplies
P
Repair Parts, Special Tools and Test Equipment
required for the performance of general support
supplied from the GSA/DSA, or Army supply
maintenance of the Generator, Model 31220-002,
system, and authorized for use at indicated
manufactured by Lear Siegler Inc., Power Equipment
maintenance categories.
Division, Cleveland, Ohio.
P2
Repair Parts, Special Tools and Test Equipment
B-2.
GENERAL
which are procured and stocked for insurance
The Repair Parts and Special Tools List is
purposes because the combat or military
divided into the following sections:
essentiality of the end item dictates that a
a. Repair Parts - Section II. A list of repair
minimum quantity be available in the supply
system.
parts authorized for the performance of maintenance at
P9
Assigned to items which are NSA design
the general support level in figure and item number
controlled: unique repair parts, special tools, test,
sequence. Maintenance supplies (MSUP) are listed
measuring and diagnostic equipment, which are
within the section in ascending Federal stock number
stocked and supplied by the Army COMSEC
sequence.
Logistic System and which are not subject to the
b. Special Tools, Test and Support Equipment
provisions of AR 380-41.
- Section III. A list of special tools, test and support
P10
Assigned to items which are NSA design
equipment authorized for the performance of
controlled: special tools, test, measuring and
maintenance at the general support level in figure and
diagnostic equipment for COMSEC support,
which are accountable under the provisions of
item number sequence.
AR 380-41, and which are stocked and supplied
c. Federal Stock Number and Reference
by the Army COMSEC Logistic System.
Number Index - Section IV. This section is divided as
M
Repair Parts, Special Tools and Test Equipment
follows:
which are not procured or stocked, as such, in
(1) A list of Federal stock numbers in
the supply system but are to be manufactured at
ascending numerical sequence cross-referenced to the
indicated maintenance levels. A Assemblies
illustration figure number and item number.
which are not procured or stocked as such, but
(2) A list of reference numbers in ascending
are made up of two or more units. Such
component units carry individual stock numbers
alpha-numerical sequence cross referenced to the
and descriptions, are procured and stocked
manufacturers Federal supply code, illustration figure
separately, and can be assembled to form the
number, and item number.
required assembly at indicated maintenance
B-3.
EXPLANATION OF COLUMNS.
categories.
The following provides an explanation of
X
Parts and assemblies that are riot procured or
columns in the tabular lists in Sections II and III:
stocked because the failure rate is normally
a. Source, Maintenance and Recoverability
below that of the applicable end item of
Codes (SMR), Column 1.
component. The failure of such part or assembly
should result in retirement of the end item from
the supply system.
A-1/B-1
