TM 5-6115-628-14&P
CHAPTER 4
UNIT MAINTENANCE
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
4-1.
Inspecting and Servicing Equipment. The power plant is unpacked, inspected, and serviced as
described in the following paragraphs. Unpacked equipment must be checked against the Equipment
Packing List to ensure completeness. Discrepancies must be reported in accordance with instructions
in DA Pam 738-750.
a. Unpacking Power Plant. (See figures 4-1 and 4-2.) The two power units that makeup the
AN/MJQ-15 power plant are identical except for the addition of the switch box installed on the curbside
fender of one of the units. Therefore, the unpacking procedures are typical for both. Each generator
set is packed in place on its respective trailer. Before beginning the unpacking procedure, locate and
remove Depreservation Guide.
Figure 4-1. Power Unit B, with Switch Box, Packed for Shipment.
WARNING
The steel banding used in packaging of power plant has sharp edges. Care
should be taken when cutting and handling banding to avoid injury to
personnel.
(1) Remove steel banding around plywood box(es) covering generator set and, when
unpacking unit B, the switch box.
4-1
