TM 5-6115-626-14&P
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
WARNING
The steel banding used in packaging of power unit has sharp edges. Care
should be taken when cutting and handling banding to avoid injury to
personnel.
Remove steel banding around plywood box covering generator set.
Remove lag screws securing plywood box cover over generator set and lift cover off
generator.
Remove wooden wedges and spacers from around generator set base.
Remove and save package of technical manuals secured to barrier material covering
generator.
Remove four sets of attaching hardware and drop plywood cover from beneath generator
set.
Remove barrier material and fiberboard caps from generator set.
Remove packaged fire extinguisher from within generator set enclosure. Unpack and
secure fire extinguisher in bracket on front roadside step.
Remove steel banding around accessory box, unpack, and inventory contents.
Refer to DA Form 2258, Depreservation Guide for Vehicles and Equipment, packed with
power unit and follow instructions given for putting unit in service.
Stow technical manuals in box on inside of generator set enclosure rear curbside door.
Stow all authorized accessories in accessory box.
b. Inspection and Servicing of Generator Set. Refer to Servicing Upon Receipt of Materiel in
TM 5-6115-465-12 for initial inspection and servicing procedures.
4-2
c. Inspection and Servicing of Trailer. Refer to Servicing Upon Receipt of Materiel in TM 9-2330-
205-14&P for initial inspection and servicing procedures.
