TM 11-6625-680-24P
SECTION I
INTRODUCTION
Definition
Code
1. Scope
XDA support item that is not stocked. When
This manual lists spares and repair parts; special
required, item will be procured through nor-
tools; special test, measurement, and diagnostic
mal supply channels.
equipment (TMDE), and other special support
required for performance of
equipment
NOTE
Cannibalization or salvage may be used
organizational, direct support, and general support
as a source of supply for any items source
maintenance of the AN/GSM-65, AN/GSM-65A. It
authorizes the requisitioning and issue of spares and
coded above except those coded XA and
repair parts as indicated by the source and main-
aircraft support items as restricted by
AR 700-42.
tenance codes.
(2) Maintenance code. Maintenance codes are
2. General
assigned to indicate the levels of maintenance
This Repair Parts and Special Tools List is divided
authorized to USE and REPAIR support items. The
into the following sections:
maintenance codes are entered in the third and
a. Section II. Repair Parts List. A list of spares
fourth positions of the Uniform SMR Code format
and repair parts authorized for use in the per-
as follows:
formance of maintenance. The list also includes
(a) The maintenance code entered in the third
parts which must be removed for replacement of the
position will indicate the lowest maintenance level
authorized parts. Parts lists are composed of func-
authorized to remove, replace, and use the support
tional groups in numeric sequence, with the parts in
item. The maintenance code entered in the third
each group listed in figure and item number sequen-
position will indicate one of the following levels of
ce.
maintenance:
b. Section III. Special Tools List. Not a p -
Application/Explanation
Code
plicable.
OSupport item is removed, replaced, used at the
c. Section IV. National Stock Number and Part
organizational level.
Number Index. A list, in National item iden-
HSupport item is removed, replaced, used at the
tification number (NIIN) sequence, of all National
general support level.
stock numbers (NSN appearing in the listings,
DSupport items that are removed, replaced, used
followed by a list, in alphameric sequence, of all part
at depot, mobile depot, specialized repair ac-
numbers appearing in the listings. National stock
tivity only.
numbers and part numbers are cross-referenced to
(b) The maintenance code entered in the
each illustration figure and item number ap-
fourth position indicates whether the item is to be
pearance.
repaired and identifies the lowest maintenance level
3. Explanation of Columns
with the capability to perform complete repair (i.e.,
a. Illustration. This column is divided as follows:
all authorized maintenance functions). This position
will contain one of the following maintenance codes:
(1) Figure number. Indicates the figure number
of the illustration on which the item is shown.
Application/Explanation
Code
(2) Item number. The number used to identify
H--The lowest maintenance level capable of com-
item called out in the illustration.
plete repair of the support item is the general
b. Source, Maintenance, and Recoverability
support level.
(SMR) Codes.
Z--Nonreparable. No repair is authorized.
(1) Source code. Source codes indicate the man-
(3) Recoverability code. Recoverability codes
ner of acquiring support items for maintenance,
are assigned to support items to indicate the
repair, or overhaul of end items. Source codes are en-
disposition action on unserviceable items. The
tered in the first and second positions of the
recoverability code is entered in the fifth position of
Uniform SMR Code format as follows:
the Uniform SMR Code format as follows:
Definition
Code
PAItem procured and stocked for anticipated or
known usage.
1
