TM 11-6125-240-34
flat washers (15), to detach external bearing plate (16).
nect ac stator electrical leads (50). Remove ac endbell
e. Remove four nuts (17) from opposite end of stator
assembly and armature (12) from housing (18) as an as-
housing (18). Remove four machine screws (19).
sembly. Work endbell off armature shaft.
Remove two screws (20) to detach dc stator (21) leads
j. Remove two screws (51), four flat washers (52),
from insulated dc brush holders (22). Free stator leads
two capacitor units (53), and two loop clamps (54).
from dc endbell (23) assembly and remove endbell as-
k. Remove screw (55), flat washer (56), and air duct
sembly from stator housing. Tap with fiber ma] let to
(57) from ac endbell (58). Remove two screws (59), lock-
facilitate removal.
washers (60), flat washers (61), to detach electrical
f. Remove two screws (24) to detach electrical lead
leads (62).
(25) from dc brush holders (22). Remove two screw
NOTE
(26), retaining clamps (27) and capacitor units (28)
eight screws (29 and 30), flat washers (31 and 32), and
with regulator card assemblies CSV2215-2
bushings (33) to detach brush holders (22) from dc
and CSV2215-3. If it is still installed in the ac
endbell.
endbell, remove at this time and discard,
g. Remove two brush springs (34) from each of four
along with associated hardware.
brush spring pins (35). Back out each of four setscrews
(36) to release the brush spring pins from the holders.
64) from ends of the armature shaft. Remove internal
h. Remove two screws (37), flat washers (38), bear-
bearing plate (65) from shaft.
ing plates (39 and 40), load spring (41), and shim
NOTE
washers (42) from ac endbell (43).
Removal of the ac (66) and dc (21) stators
i. Remove four screws (44), flat washers (45), and
from the stator housing (18) should only be at-
cover plate (46) from ac endbell. Remove two screws
tempted at depot maintenance, and then, only
(47), lockwashers (48), and flat washers (49), to discon-
if necessary.
4-16