TM 9-6150-228-13&P
SECTION V. UNIT MAINTENANCE PROCEDURES
4.14 SUB PANEL.
This task covers: a.
Removal
b.
Installation
INITIAL SETUP
Tools
General Safety Instructions
General Mechanics Automotive Tool Kit
(Item 2, Appendix B).
WARNING
Materials/Parts
High voltage is present in this equipment
during operation. Do not attempt making
Tags (Item 14, Appendix E).
any repairs without first shutting down all
input power from the power distribution
Personnel Required
panel. Failure to observe this warning
could result in serious injury or death.
One.
Equipment Conditions
Reference
Para 2.5 Equipment shut down.
Para 4.13 Deadfront panel assembly removed.
REMOVAL
a. Remove six screws (1, Figure 4-4) and remove panel (2).
b. Tag and disconnect electrical leads.
c. Remove edge trim (3) if damaged.
INSTALLATION
a. Install edge trim (3) if removed.
b. Connect electrical leads and remove tags.
c. Install panel (2) and secure with six screws (1). Tighten screws.
4-21