TM 9-6115-730-24
0027
DISASSEMBLY - Continued
3. Remove door holding rod (Figure 1, Item 14).
4. Remove six foam damping sheets as required.
END OF TASK
ASSEMBLY
1. Install hinge (Figure 1, Item 9) and secure with nine screws (Figure 1, Item 8) and locknuts (Figure 1, Item 7).
2. If necessary, use old foam damping sheets as templates to cut new foam damping sheets.
3. Install six foam damping sheets.
4. Install door holding rod (Figure 1, Item 14).
5. Install duct (Figure 1, Item 13) and secure with eleven washers (Figure 1, Item 12), lockwashers (Figure 1,
Item 11), and screws (Figure 1, Item 10).
END OF TASK
INSTALLATION
1. Install seal as required.
2. Install right rear door assembly (Figure 1, Item 3) and secure with nine screws (Figure 1, Item 6), washers
(Figure 1, Item 5), and lockwashers (Figure 1, Item 4).
3. Close right rear doors (Figure 1, Item 3) and (Figure 1, Item 2) and secure by rotating two latches (Figure 1,
Item 1).
END OF TASK
END OF WORK PACKAGE
0027-3/4 blank