TM 9-6115-730-24
0022
DISASSEMBLY - Continued
2. Remove eight screws (Figure 1, Sheet 2, Item 15), lockwashers (Figure 1, Sheet 2, Item 16), washers
(Figure 1, Sheet 2, Item 17), and deflector (Figure 1, Sheet 2, Item 18).
3. Remove four screws (Figure 1, Sheet 2, Item 19), lockwashers (Figure 1, Sheet 2, Item 20), washers
(Figure 1, Sheet 2, Item 21), and baffle (Figure 1, Sheet 2, Item 22).
4. Remove eight screws (Figure 1, Sheet 2, Item 23), lockwashers (Figure 1, Sheet 2, Item 24), washers (Figure
1, Sheet 2, Item 25), and baffle (Figure 1, Sheet 2, Item 26).
5. Remove twenty foam damping sheets as required.
6. Remove ten locknuts (Figure 1, Sheet 1, Item 7), screws (Figure 1, Sheet 1, Item 8), and hinge (Figure 1,
Sheet 1, Item 9).
END OF TASK
ASSEMBLY
1. If necessary, use old foam damping sheets as templates to cut new foam damping sections.
2. Install twenty foam damping sheets.
3. Install baffle (Figure 1, Sheet 2, Item 26) on duct (Figure 1, Sheet 1, Item 13), and secure with four washers
(Figure 1, Sheet 2, Item 25), lockwashers (Figure 1, Sheet 2, Item 24), and screws (Figure 1, Sheet 2,
Item 23).
4. Install baffle (Figure 1, Sheet 2, Item 22) on duct (Figure 1, Sheet 1, Item 13), and secure with four washers
(Figure 1, Sheet 2, Item 21), lockwashers (Figure 1, Sheet 2, Item 20), and screws (Figure 1, Sheet 2,
Item 19).
5. Install deflector (Figure 1, Sheet 2, Item 18) on duct (Figure 1, Sheet 1, Item 13), and secure with four
washers (Figure 1, Sheet 2, Item 17), lockwashers (Figure 1, Sheet 2, Item 16), and screws (Figure 1,
Sheet 2, Item 15).
6. Install duct (Figure 1, Sheet 1, Item 13) on rear door assembly (Figure 1, Sheet 1, Item 3) and secure with
fifteen washers (Figure 1, Sheet 1, Item 12), lockwashers (Figure 1, Sheet 1, Item 11), and screws (Figure 1,
Sheet 1, Item 10). Install door holding rod (Figure 1, Sheet 1, Item 14).
7. Install hinge (Figure 1, Sheet 1, Item 9), and secure with ten screws (Figure 1, Sheet 1, Item 8), and locknuts
(Figure 1, Sheet 1, Item 7).
END OF TASK
0022-4