TM 9-6115-730-24
0015
INSPECTION
Look for signs of a problem or trouble. You can feel, smell, hear, or see many problems. Be alert when in or around
the TQG.
Inspect the TQG to see if items are in good condition. Are they correctly assembled, stowed, and secured;
excessively worn, leaking, or corroded; or properly lubricated? Correct any problems found or notify DS
maintenance.
There are some common items to check all over the TQG. These include the following:
WARNING
Metal jewelry can conduct electricity and become entangled in generator set components.
Remove all metal jewelry when working on generator set. Failure to comply can cause injury or
death to personnel by electrocution.
High voltage is produced when this generator set is in operation. Make sure unit is completely
shut down and free of any power source before attempting any repair or maintenance on the unit.
Failure to comply can cause injury or death to personnel.
DC voltages are present at generator set electrical components even with generator set shut
down. Avoid shorting any positive with ground/negative. Failure to comply can cause injury to
personnel and damage to equipment.
WARNING
Cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract. Skin and eye
protection are required when working in contact with cleaning solvent. Avoid repeated or
prolonged contact. Work in ventilated area only. Failure to comply can cause injury or death to
personnel.
1. Dirt, grease, oil, and debris: They only get in the way and may cover up a serious problem. Keep the equip-
ment clean. Clean as you work and as needed. Use Breakthrough cleaning solvent to clean metal surfaces.
Use soap and water to clean rubber or plastic material.
2. Bolts, clamps, nuts, and screws: Continuously check for looseness. Look for chipped paint, bare metal, rust,
or corrosion around bolt and screw heads and nuts. Tighten them when you find them loose (see WP 0085).
3. Welds: Many items on the TQG are welded. To check these welds, look for chipped paint, rust, corrosion, or
gaps. When these conditions exist, notify DS maintenance on DA Form 5988-E.
4. Electrical wires, connectors, and harnesses: Tighten loose connectors. Look for cracked or broken insulation,
bare wires, and broken connectors.
5. Hoses and fluid lines: Check hoses and fluid lines for wear, damage, and leaks. Ensure clamps and fittings
are tight.
6. Hinges: Check hinges for security and operation.
7. Data plates: Check data, caution, and warning plates for security and legibility.
0015-3