CLEANING INSTRUCTIONS - Continued
Castings, Forgings, and Machined Metal Parts
Cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract. Skin and eye
protection are required when working in contact with cleaning solvent. Avoid repeated or
prolonged contact. Work in ventilated area only. Failure to comply can cause injury or death to
1. Clean inner and outer surfaces with breakthrough cleaning solvent.
2. Remove grease and accumulated deposits with a stiff bristle brush.
Cleaning with compressed air can cause flying particles. When using compressed air, wear
protective glasses and use clean, low pressure air, less than 30 psi (208 kPa). Failure to comply
can cause eye injury to personnel.
3. Blow out all tapped (threaded) holes with compressed air to remove dirt and cleaning fluids.
Electrical Cables and Rubber Components
Do not wash rubber components and electrical cables with breakthrough cleaning solvents or
mineral spirits; they will cause serious damage or destroy the material.
Wash electrical cables and rubber components with water and mild soap solution and wipe dry with rag.
All components and parts must be carefully checked to determine the following:
1. If they are serviceable for reuse.
2. If they can be repaired.
3. If they must be replaced.
Drilled and Tapped (Threaded) Holes
1. Inspect for wear, distortion, cracks, or any other damage in or around holes.
2. Inspect threaded areas for wear, distortion (stretching), or evidence of cross-threading.
3. Mark all damaged areas for repair or replacement.