CORROSION PREVENTION AND CONTROL (CPC) - Continued
Quality Deficiency Report. Use of key words such as "corrosion," "rust," "deterioration," or "cracking" will ensure
that the information is identified as a CPC problem. The form should be submitted to the address specified in DA
PAM 750-8. Air Force personnel will use TO 25-1-3.
DESTRUCTION OF ARMY MATERIAL TO PREVENT ENEMY USE
Refer to TM 750-244-2 for demolition procedures when equipment destruction is required.
PREPARATION FOR STORAGE OR SHIPMENT
Requirements for packaging and administrative storage are contained in TM 9-6115-729-10. Requirements for
short and long term storage are in WP 0087.
This section provides information on the Warranty for generator set components. See Table 1 for list of warranted
components (this work package).
Check the Insp Date on the end-item data plate on the generator set. If the Insp Date is prior to
09/06, the (12) month Warranty period shall begin on 08/31/06.
If the Insp Date on the data plate is 09/06 or after, the standard (12) month Warranty begins on the
Warranty service may be obtained through two methods.
1. a. (ARMY ONLY) Fill out the preferred warranty claim SF 368, Product Quality Deficiency Report, or fill out a
warranty claim per DA PAM 738-750. The DA Form 2407, Maintenance Request, is also acceptable. Mail
completed form to Commander, US Army, Communications-Electronics Life Cycle Management Command,
ATTN: AMSEL-LC-CCS-G-GN, 1200 Nealis Avenue, Fort Monmouth, New Jersey 07703-5043. At a
minimum, the end item NSN, serial number, and date of shipment to the government, and the defective
component part number/CAGE must be included in the documentation.
b. (OTHER SERVICES) For reporting warranty claims, fill out and forward SF 368 on DA Form 2407 to US
Army Communications-Electronics Life Cycle Management Command, ATTN: AMSEL-LC-CCS-G-GN, 1200
Nealis Avenue, Fort Monmouth, NJ 07703-5043.
2. Warranty service can be obtained by contacting the actual warranted component manufacturer listed in
column 1. Each manufacturer will provide instructions on filing the claim.
3. Troubleshooting should be performed to the level of warranted component, but no further unless directed by
the warranted component manufacturer. Troubleshooting to the failed part inside warranted components may
invalidate the warranty.
4. There are some components with short warranty periods that may not be listed in Table 1. Warranty
coverage may be available for these components. Submit warranty claims in accordance with DA PAM 738-
750 to determine if the components are covered.
5. If you have difficulty with or questions about the warranty process, contact your local CECOM LAR or the
CECOM Generator Branch, DSN 992-1313, (732) 532-1313.