ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
NOTES:
PROCEDURES:
1. Cut each wire (3) to length indicated, then strip
1. Dimensions are shown in inches and
0.50 [13] from ends of each wire.
dimensions in [ ] are in millimeters.
2. Insert wires (3) into each pin from connector (1)
and crimp using crimping tool.
for materials required.
3. Slide 0.75 to 1.25 [19.1 to 31.8] of insulation
3. Connector shall be marked "J1" on insulation
sleeving (2) over wires (3).
sleeving with 0.18 [5] minimum high characters
IAW MIL-STD-130 using rubber stamp or
4. Using a pin insertion tool, insert pins from
stencil.
connector (1) into connector (1) until pins
lock into place, following termination
indicators in wire list reference table.
5. Slide insulation sleeving (2) to connector (1),
and heat shrink to a firm fit.
6. Slide insulation sleeving (13) over wire bundle
to connector (1), and heat shrink to a firm fit.
7. Slide insulation sleeving (2) over each of the
wire reference numbers 2, 3, 4, 5 and 6.
8. Slide terminal lug (5) onto wire reference
numbers 2, 3, 4, 5 and 6 and crimp. Slide
insulation sleeving (2) over terminal lugs (5)
and heat shrink to a firm fit.
9. Slide terminal lug (4) onto wire reference
number 1 and crimp.
10. Mark the appropriate wire number which will
consist of the `FROM' termination, a double-
headed arrow (↔), and the `TO' termination.
Figure G-8. Wiring Harness, Control Panel (P/N: 95-8075)(Sheet 2 of 2)
G-13