(b) Fasten socket (4) to bracket (11) with two mounting studs (10) and two nuts (9).
(c) Connect terminal (6) end of four wires to bottoms of diodes (5).
(d) Solder bare wire ends of four wires to tops of diodes (5).
(e) Connect opposite end of each wire to terminal board TB1 (7). (See figure 4-9 for wire routing
Bind harness wires together using tiedown straps (8).
(g) Plug relay (3) into socket (4) and secure with two screws (1).
(h) Close and secure PDU cover.
Figure 4-15. Control Relay/Diodes Wiring Harness Replacement.
PDU Relay K3 Testing and Replacement. (See figure 4-16).
(1) Release cover latch and open PDU cover.