TB 9-6115-643-13
IGNITER/GLOW PLUG AND RESISTOR MAINTENANCE.
This tasks covers:
a. Test
b. Replace
INITIAL SETUP
Tools
Equipment Conditions
Tool Kit, General Mechanic's
Reference
Generator shut down, TM 9-6115-643-10, Paragraph 2-9.2
WARNING
Disconnect negative battery cable from right battery and the positive
battery cable from the left battery before doing the following
procedures. Failure to observe this warning could result in severe
personal injury or death.
TEST
1.
Disconnect negative battery terminal.
2.
`
3.
Disconnect wires from igniter/glow plug and resistor.
4.
REPLACEMENT
1.
Disconnect negative battery cable.
2.
Remove caps (5) from igniter/glow plug (4) and/or resistor (1). Loosen hex nuts (2) on igniter/glow plug (4) and/or
resistor (1). Remove cable (3).
3.
Unscrew igniter/glow plug (4) and/or resistor (1), as required, and remove it. Use an angled hook to clean the
igniter/glow plug hole.
4.
Install igniter/glow plug (4) and/or resistor (1).
5.
Install plug cable (3), hex nuts (2), and caps (5).
6.
Reconnect negative battery cable.